Cl-i-max Models - AXI Mounts

OUTRUNNER
MOTOR MOUNTS

AXI, MEGA 400

10x10 mm Stick Mountable

Gives the same 4mm
Shaft-Center to Stick-Bottom
offset as the GWS gearboxes

Laser cut plywood kit

M3x10mm Screws Included

Outrunners with the 16mm/19mm mounting hole pattern can
use these mounts. Check mount DATA for motor length clearance.


AXI2208 OUT OF STOCK		$5.00us

AXI 2212 OUT OF STOCK		$5.00us Can also Accommodate - AXI 2208.

AXI2808 MEGA 400/15/7 OUT OF STOCK		$5.00us Can also Accommodate - AXI 2212 and 2208

AXI 2208/2212/2808 OUT OF STOCK		$5.00us Use with Bell Housing Prop Adapter (AXI 2208 Shown)

* Prop Adaptors not included

Assembly Instructions

Remove parts from carrier sheet. Flexing along wood grain near keeper tabs works best. Small pieces are removed by twisting pieces to be removed on the keeper tabs.
Using a small file remove the remnants of the keeper tabs from those edges that mate with other pieces. A light filing of the all mating edges is recommended.
Assemble pieces.
Wick all joints with thin cyanoacrolate glue.
Seal wood with clear dope, wood lacquer or similar (optional).
Mount to 10 x 10mm stick with two screws.

Jon Le Mon's AXI 2808/Mini Funtana Installation